Paul & Sue Liles
A Small Corner On The Internet Dedicated To Our Family & Friends
Before And After X-rays
X-rays (or Röntgen rays) are a form of electromagnetic radiation with
a wavelength in the range of 10 to 0.01 nanometers, corresponding to frequencies
in the range 30 to 30 000 PHz (1 PHz = 1015 Hertz). X-rays are primarily
used for diagnostic radiography and crystallography. X-rays are a form of
ionizing radiation and as such can be dangerous. In many languages it is
called Röntgen radiation after one of the first investigators of the X-rays,
Wilhelm Conrad Röntgen.
They took x-rays before and after the operation to be able to see the actual
angular difference.
Posterolateral fusion places the bone graft between the transverse processes
in the back of the spine. These vertebrae are then fixed in place with screws
and/or wire through the pedicles of each vertebrae attaching to a metal
rod on each side of the vertebrae.
Interbody fusion places the bone graft between the vertebra in the area
usually occupied by the intervertebral disc. In preparation for the spinal
fusion, the disc is removed entirely. A device may be placed between the
vertebra to maintain spine alignment and disc height. The intervertebral
device may be made from either plastic or titanium. The fusion then occurs
between the endplates of the vertebrae. Using both types of fusion is known
as 360-degree fusion. Fusion rates are higher with interbody fusion. Sue
had an interbody fusion known as Anterior lumbar interbody fusion
(ALIF)- an anterior abdominal incision is used to reach the lumbar spine
Lateral View, Prior To The Operation
Lateral View Pre Operation
This lack of spacing means the material that is supposed to be between the bones is degenerated (i.e. missing) and the bones are rubbing against each other which accounts for the extreme pain and other effects on the nervous system.
Those effects are due to pinched nerves which accounts for the inability to stand or walk for any significant time. Obviously if not fixed, the pain will continue to get worse.
Careful look at the x-ray reveals the doctors geometry calculations and alignment issues.
Lateral View, Afterwards
Lateral View Post Operation
After the operation, one can see the screws go
through the titanium rods and into the backbone.
Screws are between 45-50mm in length (i.e. 2"). The surgeon refers to
the braces and screws as "instrumentation". The screws hold the backbone
in place not allowing it to turn (rotate) nor sag.
Notice the white color between the screws on the lower extremities. These
are where bone was placed into the area where the disks were removed (eight
places).
The bone and back will eventually (1-2 years) fuse into a single stiff bone.
The rods and screws stabilized the back from additional deterioration
Spinal fusion, also known as spondylosyndesis is a surgical technique used
to combine two or more vertebrae. Supplementary bone tissue (either autograft
or allograft) is used in conjunction with the body's natural osteoblastic
processes.
This procedure is used primarily to eliminate the pain caused by abnormal
motion of the vertebrae by immobilizing the vertebrae themselves.
Front View, Before
Front View Pre-Operation
Look at the curvature of the backbone which caused severe pain from "falling over". The angle is almost 45 degrees!
This was the total angle of the backbone at the top and at the bottom.
This angle was possible because the grinding of the normal material between the individual bones causing extreme stress on the nerve bundles and the associated pain.
The pain was felt throughout the lower extremities because of the various nerves affected.
Again note the calculations on the x-ray. (Click to see and enlarged picture) The curvature was 48 degrees from vertical (the normal condition).
The surgeon was able to correct it back to nearly 10 degrees. A
full correction was not possible as the stress on the bones would be too
much.
Front View, Afterwards
Post Operation Frontal View
This view after the operation clearly shows the "railroad tracks? that run the entire length of Sue's back and the significant adjustment that was made.
With the curve was a twist of almost 48 degrees from normal.
This twist was pinching the nerves making her unable to walk and with continuous pain.
The rods/screws stabilize the back and returned the back to no more than a 14 degree rotation.
The operation was 14 hours long to place the 27 screws into the backbone
The titanium rods traversing up the back on either side of the spine are clearly viewed.
The circles are the places in the rods where screws were used to tie to the spine (27 places)